Alternatively, the same can be achieved upon running the following command from PowerShell (Running as an Admin)ĭisable-NetAdapterBinding -Name * -DisplayName "Juniper Network Service"
From the list, uncheck the checkbox for Juniper Network Service & Click OKĨ.Right-click the adapter and select Properties.From the Network Connections, select Pulse Secure virtual adapter.If the Pulse tunnel is not connected, the virtual adapter does not appear in the Network Connections.) (This is necessary to change the virtual adapter settings. From the list, uncheck the checkbox for Juniper Network Service.Right-click on the adapter and select Properties.
Locate the physical adapter in the Network Connections.Open Control Panel and select Network and Sharing Center the select Change adapter settings.įrom a DOS command prompt run the command:.See below for a workaround that can be applied to SRX connections). The following solutions have been implemented by our customers successfully, Solution # 1: Disable the Juniper Network Services from the physical and virtual adapter: (If the Pulse connection is being used to connect to an SRX device, then this should not be performed. This issue is caused due to an interoperability with the Juniper Network Service which binds to physical adapters when Pulse Desktop Client is installed.
#Network connect juniper download mac windows
#Network connect juniper download mac windows 10
This article describes an issue on Windows 10 where end user experiences slow download speeds/unable to access resources over Wi-Fi adapter via Pulse Desktop client on Windows 10